Feasibility analysis of IR seeker closed-loop simulation based on digital image injection
-
摘要: 针对红外成像导引头复杂战场环境适应性测试，提出了一种采用数字图像注入式的闭环半实物仿真试验方法，并分析了闭环注入式仿真试验系统的组成及工作原理。由于仿真测试时红外成像导引头的传感器被图像仿真计算机和图像注入接口设备取代，导致数字图像生成及脱靶量计算环节存在延迟和误差，使伺服控制系统的性能与实际工作情况可能不一致，从而影响仿真试验结果精度和置信度，因此，在建立导引头伺服控制系统模型的基础上，研究了仿真时间延迟、脱靶量误差对伺服控制系统的影响。研究结果表明：由于脱靶量误差对跟踪精度的影响仅为1.33%，如果将时间延迟控制在56.5 ms之内，开展闭环注入式仿真试验是可行的，该结果可为下一步开展红外成像导引头闭环注入式仿真试验提供理论支持。Abstract: Focusing on the adaptability testing of IR seeker in complicated battlefield environment, a new closed-loop simulation test method of using digital image injection was proposed, the composing and principle of closed-loop simulation test system were analyzed. The detector of IR seeker was replaced by image simulation computer and injection device in the simulation condition, thus the performance of servo system was likely to differ from that under the actual conditions due to the image generation delay and miss distance error, which affected the precision and reliability of simulation test result. The influence of time delay and miss distance error on seeker's servo system by building servo system model was studied. The research result indicates that the influence of miss distance error on track precision is only 1.33%, the closed-loop simulation is feasible if time delay is less than 56.5 ms. The results of research provide theoretical support for actualizing closed-loop injection simulation test of IR imaging seeker.
-
Key words:
- IR imaging seeker /
- closed-loop injection simulation /
- time delay /
- miss distance error
-
[1] Bai Lin. Means and the development trend of the inter-ference infrared imaging guided weapons[J]. Ship Electronic Engineering, 2009, 29(4): 34-38. (in Chinese) 白林. 干扰红外成像制导武器的手段与发展动向[J]. 舰船 电子工程, 2009, 29(4): 34-38. [2] [3] Wu Junhui, Zhu Zhen, Xue Fangxia, et al. Study on loop-locked IR capturing and tracking simulation based on digital image injection [J]. Journal of System Simulation, 2004,16(9): 2067-2070. (in Chinese) 吴军辉, 朱震, 薛芳侠, 等. 数字图像注入式红外捕获跟踪 闭环仿真试验探讨[J]. 系统仿真学报, 2004, 16 (9): 2067-2070. [4] [5] Wang Xuewei, Shen Tongsheng, Zhou Xiaodong. Infrared image generation system based on signal injection [J]. Infrared and Laser Engineering, 2003, 32(6): 568-571. (in Chinese) 王学伟.沈同圣.周晓东. 基于信号注入的红外热成像生成 系统[J].红外与激光工程, 2003, 32(6): 568-571. [6] [7] Zhang Zhiyong, Zhou Xiaoyao, Fan Dapeng, et al. Design and analysis of control system for seeker servo mechanism[ J]. Infrared and Laser Engineering, 2012, 41(2): 1494-1499. (in Chinese) 张智永, 周晓尧, 范大鹏, 等. 导引头伺服机构的控制系统 分析与设计[J] . 红外与激光工程, 2012, 41(2): 1494-1499. [8] [9] Yang Xiaoying, Cui Dedong. Simulation analysis of the angle tracing system for infrared imaging seeker [J]. Infrared and Laser Engineering, 2007, 36(1): 39-51. (in Chinese) 杨晓英, 崔得东. 红外成像导引头角跟踪系统仿真分析[J]. 红外与激光工程, 2007, 36(1): 39-51. [10] [11] Ma Jiaguang. The basic technologies of the acquisition tracking and pointing systems [J]. Optics Engineering, 1989, 81(3): 31-42. (in Chinese) 马佳光. 捕获跟踪与瞄准系统的基本技术问题[J]. 光学工 程, 1989, 81(3): 31-42. [12] [13] Zhao Chao. Effects of time delay and its compensation algorithm in a seeker's servo system[J]. Infrared and Laser Engineering, 2008, 37(6): 1066-1069. (in Chinese) 赵超. 导引头随动系统中信号处理延迟的影响及其补偿算 法[J]. 红外与激光工程, 2008, 37(6): 1066-1069. [14] [15] Wang Lianming, Ge Wenqi, Xie Mujun. Influences of sample frequency and delays on tracking system [J]. Optics and Precision Engineering, 2000, 8(4): 369-372. (in Chinese) 王连明.葛文奇.谢幕君. 采样频率尧系统延迟对跟踪系统 稳定性能的影响[J]. 光学精密工程, 2000, 8(4): 369-372. -
点击查看大图
计量
- 文章访问数: 353
- HTML全文浏览量: 41
- PDF下载量: 151
- 被引次数: 0
下载:
