Zhang Jiakun, Yang Baoyu, Sun Dexin. Common-mode interference mechanism of the driving circuit of cryocooler used on infrared system[J]. Infrared and Laser Engineering, 2020, 49(1): 0104001-0104001(9). doi: 10.3788/IRLA202049.0104001
Citation:
|
Zhang Jiakun, Yang Baoyu, Sun Dexin. Common-mode interference mechanism of the driving circuit of cryocooler used on infrared system[J]. Infrared and Laser Engineering, 2020, 49(1): 0104001-0104001(9). doi: 10.3788/IRLA202049.0104001
|
Common-mode interference mechanism of the driving circuit of cryocooler used on infrared system
-
1. Shanghai Institute of Technical Physics, Chinese Academy of Sciences, Shanghai 200083, China;
-
2. University of Chinese Academy of Sciences, Beijing 100049, China
- Received Date: 2019-10-11
- Rev Recd Date:
2019-11-21
- Publish Date:
2020-01-28
-
Abstract
Cryocooler is an important equipment to provide low temperature working environment for infrared device. However, its driving system's conducted interference severely affects the precision of the infrared loading. It's not easy to analyze the common-mode part included in conducted interference. To study the common-mode interference mechanism, based on an existing infrared system project's cryocooler and its driving system, the mechanism was quantitatively analyzd using a new multi-physics co-simulation method and the model's accuracy was verified by specific experiment measurement. Finally, the characteristic of disturbance pathway and source were analyzed and the mechanism of the common-mode interference was concluded. Results show that, the parasitic parameter of the cryocooler is the most important factor of transmission path within the range of test frequency. However, with frequency increase, the effect of cable's parasitic parameter is increasing and can't be ignored. The interference mechanism concludes that the common mode interference produced by system may induce the overrun of the CE102 standard from 500 kHz to 1 MHz.
-
References
[1]
|
Paul C R, Hardin K B. Diagnosis and reduction of conducted noise emissions[J]. IEEE Transactions on Electromagnetic Compatibility, 1988, 30(4):553-560. |
[2]
|
Zhang H, Wang S, Puukko J. Common mode EMI noise modeling and prediction for a three-phase, three-level, grid tied photovoltaic inverter[C]//Asia-Pacific International Symposium on Electromagnetic Compatibility, IEEE, 2016:1188-1194. |
[3]
|
Zhai L, Lin L, Song C, et al. Mitigation conducted-EMI emission strategy based on distributed parameters of power inverter system in electric vehicle[C]//Power Electronics Conference, IEEE, 2017. |
[4]
|
Sunitha P M, Banakara B, Reddy S. Modeling, simulation and analysis of common mode voltage, bearing voltage and bearing current in PWM multilevel inverter fed induction motor with long cable[C]//IEEE International Conference on Recent Trends in Electronics, IEEE, 2018. |
[5]
|
Toure B, Schanen J L, Gerbaud L, et al. EMC modeling of drives for aircraft applications:modeling process, EMI filter optimization, and technological choice[J]. IEEE Transactions on Power Electronics, 2013, 28(3):1145-1156. |
[6]
|
Shinde S, Masuda K, Shen G, et al. Radiated EMI estimation from DC-DC converters with attached cables based on terminal equivalent circuit modeling[J]. IEEE Transactions on Electromagnetic Compatibility, 2017, 99:1-8. |
[7]
|
Gwon O H, Jeon J W, Ahn J, et al. Component characteristics of motor drive system in EV/HEV and its noise spectrum analysis[C]//International Conference on Electrical Machines & Systems, IEEE, 2014. |
-
-
Proportional views
-